T-Motor FT5 6S Freestyle 1950KV

5 Zoll Freestyle mit besten Komponenten wie T-Motor PACER P2207.5 1950KV 6S Motoren, P50A BLheli_32 ESC’s, RUSH TANK 25-800mW VTX, Caddx Ratel Kamera und T-Motor F4 FC. Fliegt super gut mit RPM Filter und Betaflight 4.2.1

Hole dir den T-Motor FT5 225mm F4 6S bei Banggood

T-Motor FT5 225mm F4 6S – Coupon: BGFT56S – https://www.banggood.com/custlink/GvmRRgQ9uz

T-Motor FT5 225mm F4 4S – Coupon: BGaFf10oFf – https://www.banggood.com/custlink/GvGKudBtQJ
5 Zoll Freestyle für guten Preis und besten Komponenten wie T-Motor V2306 2400KV 4S Motoren, 45A BLheli_32 ESC’s, RUSH TANK 25-800mW VTX, Caddx Ratel Kamera und T-Motor F4.

T-MOTOR FT5 HD 5.1 Freestyle – Coupon: BGFT5HD – https://www.banggood.com/custlink/DKmRht7LRe
5 Zoll Freestyle von T-Motor mit 5mm Armen, F4 FC, 60A ESC’s und F60Pro IV 2550KV 4S oder 1750KV 6S Motoren. Hinten die Caddx Vista für DJI Brille.

Gute FPV Caddx Ratel Kamera

Gute 6S Pacer P2207.5 1950KV Motoren

Hinten Rush Tank sehr guter VTX mit 25-800mW

6S GNB 1050mAh Lipo – https://www.banggood.com/custlink/mv3DglOsdY

Guter Carbon Rahmen mit 5mm dicken Armen

Im Lieferumfang nur ein Satz Propeller T-Motor 5143
https://www.banggood.com/custlink/KvGdCdjTFL

Leicht zugänglich der Stack mit 50A BLHeli_32 ESC’s und F4 FC

Hier der angeschlossener FrSky XM+ Empfänger

So wird ein DSMX, Flysky oder FrSky XM+ angeschlossen

Anschluss von Crossfire an T5 R5 UART5

Der Stack sitzt stabil befestigt mit Metalschrauben und unten mit Muttern

390 Gramm Leergewicht

560 Gramm mit 1050mAh Akku

667 Gramm mit GoPro Session 5

707 Gramm mit dem guten Tattu R-Line V3.0 1300mAh 6S Akku

Meine Einstellungen mit Betaflight 4.2.1

# Einstellungen 2020-07-22 mit FrSky XM+
# version
# Betaflight / STM32F405 (S405) 4.2.1 Jul 19 2020 / 06:18:01 (caa0d683c) MSP API: 1.43
# config: manufacturer_id: TMTR, board_name: TMOTORF4, version: 3a35e73b, date: 2019-09-30T05:46:12Z
# start the command batch
batch start
# reset configuration to default settings
defaults nosave
board_name TMOTORF4
manufacturer_id TMTR
mcu_id 001a002f324d500220303256
signature 
# name: T-MOTOR FT5
# feature
feature -RX_PARALLEL_PWM
feature RX_SERIAL
feature TELEMETRY
# beeper
beeper -GYRO_CALIBRATED
beeper -RX_LOST
beeper -RX_LOST_LANDING
beeper -DISARMING
beeper -ARMING
beeper -ARMING_GPS_FIX
beeper -BAT_CRIT_LOW
beeper -BAT_LOW
beeper -GPS_STATUS
beeper -ACC_CALIBRATION
beeper -ACC_CALIBRATION_FAIL
beeper -READY_BEEP
beeper -DISARM_REPEAT
beeper -ARMED
beeper -SYSTEM_INIT
beeper -ON_USB
beeper -BLACKBOX_ERASE
beeper -CRASH_FLIP
beeper -CAM_CONNECTION_OPEN
beeper -CAM_CONNECTION_CLOSE
beeper -RC_SMOOTHING_INIT_FAIL
# beacon
beacon RX_SET
# map
map TAER1234
# serial
serial 1 2048 115200 57600 0 115200
serial 4 64 115200 57600 0 115200
# aux
aux 0 0 0 1700 2100 0 0
aux 1 1 1 900 1300 0 0
aux 2 2 1 1300 1700 0 0
aux 3 13 2 1700 2100 0 0
aux 4 35 2 1300 1700 0 0
# rxrange
rxrange 0 988 2011
rxrange 1 988 2011
rxrange 2 988 2011
rxrange 3 988 2011
# vtxtable
vtxtable bands 5
vtxtable channels 8
vtxtable band 1 BOSCAM_A A FACTORY 5865 5845 5825 5805 5785 5765 5745 5725
vtxtable band 2 BOSCAM_B B FACTORY 5733 5752 5771 5790 5809 5828 5847 5866
vtxtable band 3 BOSCAM_E E FACTORY 5705 5685 5665 5645 5885 5905 5925 5945
vtxtable band 4 FATSHARK F FACTORY 5740 5760 5780 5800 5820 5840 5860 5880
vtxtable band 5 RACEBAND R FACTORY 5658 5695 5732 5769 5806 5843 5880 5917
vtxtable powerlevels 4
vtxtable powervalues 0 1 2 3
vtxtable powerlabels 25 200 500 800
# master
set gyro_lowpass2_hz = 475
set dyn_notch_width_percent = 0
set dyn_notch_q = 250
set dyn_notch_min_hz = 90
set dyn_notch_max_hz = 350
set dyn_lpf_gyro_min_hz = 380
set dyn_lpf_gyro_max_hz = 950
set acc_calibration = -6,-17,-41,1
set mag_hardware = NONE
set baro_hardware = NONE
set rssi_channel = 16
set rc_smoothing_auto_smoothness = 7
set serialrx_provider = SBUS
set min_throttle = 1070
set dshot_idle_value = 500
set dshot_bidir = ON
set use_unsynced_pwm = OFF
set motor_pwm_protocol = DSHOT600
set motor_pwm_rate = 480
set small_angle = 180
set osd_vbat_pos = 2497
set osd_rssi_pos = 2369
set osd_tim_2_pos = 2519
set osd_flymode_pos = 2456
set osd_throttle_pos = 2433
set osd_vtx_channel_pos = 1
set osd_current_pos = 2486
set osd_craft_name_pos = 2505
set osd_warnings_pos = 14761
set osd_avg_cell_voltage_pos = 2465
set vtx_band = 5
set vtx_channel = 6
set vtx_power = 1
set vtx_freq = 5843
set gyro_rpm_notch_q = 700
set name = T-MOTOR FT5
profile 0
# profile 0
set dyn_lpf_dterm_min_hz = 133
set dyn_lpf_dterm_max_hz = 323
set dyn_lpf_dterm_curve_expo = 7
set dterm_lowpass2_hz = 285
set vbat_sag_compensation = 100
set iterm_relax_cutoff = 20
set yaw_lowpass_hz = 100
set throttle_boost = 7
set throttle_boost_cutoff = 25
set p_pitch = 55
set d_pitch = 46
set f_pitch = 133
set p_roll = 50
set d_roll = 42
set f_roll = 126
set p_yaw = 54
set f_yaw = 126
set d_min_roll = 28
set d_min_pitch = 30
set ff_interpolate_sp = AVERAGED_3
set ff_spike_limit = 70
set ff_smooth_factor = 20
profile 1
profile 2
# restore original profile selection
profile 0
rateprofile 0
# rateprofile 0
set roll_rc_rate = 140
set pitch_rc_rate = 140
set yaw_rc_rate = 120
set roll_expo = 30
set pitch_expo = 30
set yaw_expo = 20
set roll_srate = 75
set pitch_srate = 75
rateprofile 1
rateprofile 2
rateprofile 3
rateprofile 4
rateprofile 5
# restore original rateprofile selection
rateprofile 0
# save configuration
save

Original Einstellungen mit Betaflight 4.1.1

# Original Einstellungen 2020-07-21
# version
# Betaflight / TMOTORF4 (TMR4) 4.1.1 Nov 15 2019 / 12:57:53 (1e5e3d369) MSP API: 1.42
# start the command batch
batch start
# reset configuration to default settings
defaults nosave
board_name TMOTORF4
manufacturer_id TMTR
mcu_id 001a002f324d500220303256
signature 
# name: T-MOTOR FT5
# feature
feature -AIRMODE
# beeper
beeper -GYRO_CALIBRATED
beeper -RX_LOST
beeper -RX_LOST_LANDING
beeper -DISARMING
beeper -ARMING
beeper -ARMING_GPS_FIX
beeper -BAT_CRIT_LOW
beeper -BAT_LOW
beeper -GPS_STATUS
beeper -RX_SET
beeper -ACC_CALIBRATION
beeper -ACC_CALIBRATION_FAIL
beeper -READY_BEEP
beeper -DISARM_REPEAT
beeper -ARMED
beeper -SYSTEM_INIT
beeper -ON_USB
beeper -BLACKBOX_ERASE
beeper -CRASH_FLIP
beeper -CAM_CONNECTION_OPEN
beeper -CAM_CONNECTION_CLOSE
beeper -RC_SMOOTHING_INIT_FAIL
# serial
serial 1 2048 115200 57600 0 115200
# vtxtable
vtxtable bands 5
vtxtable channels 8
vtxtable band 1 BOSCAM_A A FACTORY 5865 5845 5825 5805 5785 5765 5745 5725
vtxtable band 2 BOSCAM_B B FACTORY 5733 5752 5771 5790 5809 5828 5847 5866
vtxtable band 3 BOSCAM_E E FACTORY 5705 5685 5665 5645 5885 5905 5925 5945
vtxtable band 4 FATSHARK F FACTORY 5740 5760 5780 5800 5820 5840 5860 5880
vtxtable band 5 RACEBAND R FACTORY 5658 5695 5732 5769 5806 5843 5880 5917
vtxtable powerlevels 4
vtxtable powervalues 0 1 2 3
vtxtable powerlabels 25 200 500 800
# master
set acc_calibration = -78,-193,-29
set mag_hardware = NONE
set baro_hardware = NONE
set min_throttle = 1070
set use_unsynced_pwm = OFF
set motor_pwm_protocol = DSHOT600
set motor_pwm_rate = 480
set small_angle = 45
set pid_process_denom = 2
set osd_craft_name_pos = 2441
set name = T-MOTOR FT5
profile 0
profile 1
profile 2
# restore original profile selection
profile 0
rateprofile 0
rateprofile 1
rateprofile 2
rateprofile 3
rateprofile 4
rateprofile 5
# restore original rateprofile selection
rateprofile 0
# save configuration
save